Nvidia Jetson: Flashing Custom Firmware

From Humanoid Robots Wiki
Revision as of 00:33, 4 June 2024 by Vedant (talk | contribs) (Created page with "= Developing Custom Firmware = == For the Jetson Orin Nano == = Flashing = = Notes: - Current Design constraints: - Based off of the availability of parts in JLCPCB....")
(diff) ← Older revision | Latest revision (diff) | Newer revision → (diff)
Jump to: navigation, search

Developing Custom Firmware

For the Jetson Orin Nano

Flashing

=


Notes: - Current Design constraints: 

  - Based off of the availability of parts in JLCPCB. Possibility of parts not being found or existing. 
  -

- Flashing is done with the flash.sh script through the following command 

$ sudo ./flash.sh <board> <rootdev>
where board is the actual board (Jetson-Nano-XX, etc.)

rootdev determines what type of device is being flahed. Use mmcblk0pc1 to flash a local storage device (eMMC or SD card) - TO begin flashing, put the device into force recovery mode and then press reset. - Run the flash script using the previous command specified.

Flash using a convenient script: - To avoid having to specify the rootdev andthe board configurations, can use the custom flashing script: 

 -

Using GPIO Pins to program protocol: - you can use the rasberry pi libraries to interface with the pins, configuring them to whatever layout that is needed. 

  - Example: it is possible to direclty interface with the i2c system in the nano by using the
Retrieved from "https://humanoids.wiki/index.php?title=Nvidia_Jetson:_Flashing_Custom_Firmware&oldid=1431"