Prismatic VLM REPL

The K-Scale OpenVLA adaptation by User:Paweł is at https://github.com/kscalelabs/openvla

REPL Script Guide

Here are some suggestions to run the generate.py REPL Script from the repo (you can find this in the scripts folder) if you would like to get started with OpenVLA.

Prerequisites

Before running the script, ensure you have the following:

• Python 3.8 or higher installed
• NVIDIA GPU with CUDA support (optional but recommended for faster processing)
• Hugging Face account and token for accessing Meta Lllama

Setting Up the Environment

In addition to installing requirements-min.txt from the repo, you probably need to install rich, tensorflow_graphics, tensorflow-datasets and dlimp.

Set up Hugging Face token

You need a Hugging Face token to access certain models. Create a .hf_token file thats needed by the script.

Create a file named `.hf_token` in the root directory of your project and add your Hugging Face token to this file:

echo "your_hugging_face_token" > .hf_token

Sample Images for generate.py REPL

You can get these by capturing frames or screenshotting rollout videos from

 https://openvla.github.io/ 

Make sure the images have an end effector in them.

Starting REPL mode

Then, run generate.py. The script starts by initializing the generation playground with the Prismatic model prism-dinosiglip+7b.

The model prism-dinosiglip+7b is downloaded from the Hugging Face Hub.

The model configuration is found and then the model is loaded with the following components:

Vision Backbone: dinosiglip-vit-so-384px

Language Model (LLM) Backbone: llama2-7b-pure (this is also where the hf token comes into play)

Architecture Specifier: no-align+fused-gelu-mlp

Checkpoint Path: The model checkpoint is loaded from a specific path in the cache.

You should see this in your terminal:

After loading the model, the script enters a REPL mode, allowing the user to interact with the model. The REPL mode provides a default generation setup and waits for user inputs.

Basically, the generate.py script runs a REPL that allows users to interactively test generating outputs from the Prismatic model prism-dinosiglip+7b. Upon running the script, users can enter commands in the REPL prompt:

type (i) to load a new local image by specifying its path, (p) to update the prompt template for generating outputs, (q) to quit the REPL, or directly input a prompt to generate a response based on the loaded image and the specified prompt.

work in progress,need to add screenshots and next steps