Difference between revisions of "Nvidia Jetson: Flashing Custom Firmware"

From Humanoid Robots Wiki
Jump to: navigation, search
(For the Jetson Orin Nano)
Line 1: Line 1:
 
= Developing Custom Firmware =  
 
= Developing Custom Firmware =  
== For the Jetson Orin Nano ==  
+
== For the Jetson Orin Nano ==
  
 
= Flashing =  
 
= Flashing =  

Revision as of 00:36, 4 June 2024

Developing Custom Firmware

For the Jetson Orin Nano

Flashing

Notes: - Current Design constraints:

  - Based off of the availability of parts in JLCPCB. Possibility of parts not being found or existing. 
  - 

- Flashing is done with the flash.sh script through the following command

$ sudo ./flash.sh <board> <rootdev>
where board is the actual board (Jetson-Nano-XX, etc.)

rootdev determines what type of device is being flahed. Use mmcblk0pc1 to flash a local storage device (eMMC or SD card) - TO begin flashing, put the device into force recovery mode and then press reset. - Run the flash script using the previous command specified.

Flash using a convenient script: - To avoid having to specify the rootdev andthe board configurations, can use the custom flashing script:

 - 

Using GPIO Pins to program protocol: - you can use the rasberry pi libraries to interface with the pins, configuring them to whatever layout that is needed.

  - Example: it is possible to direclty interface with the i2c system in the nano by using the linux terminal itself.