Difference between revisions of "Gripper History"
(→Updated Version 7) |
(→Updated Version 7) |
||
| Line 37: | Line 37: | ||
=== Updated Version 7 === | === Updated Version 7 === | ||
Switched cuts to the inside wall and eliminated redundant rib. | Switched cuts to the inside wall and eliminated redundant rib. | ||
| − | [[File:Stompy gripper | + | [[File:Stompy gripper 7.jpg|none|300px|Updated version 7]] |
Revision as of 08:29, 2 June 2024
Contents
Gripper Design Iterations
Updated Version 7
Switched cuts to the inside wall and eliminated redundant rib.
Updated Version 1
Made ribs thinner at their ends so that they would bend more easily. Added triangular cuts along the inner surface to allow the material to flex. Problems: The triangular cut closest to the tip caused the inner surface of the grippers to tear.
Updated Version 2
Moved slots to only align with the three thickest ribs, reducing potential for tears. Created an angled profile where the tips of the grippers are narrower than the base. Problems: Screw holes were too large for screws to be inserted from below, tears persisted in some cases.
Updated Version 3
Decreased hole size to allow for better threading. Problems: Tears persisted, insufficient clearance for hex key to actually tighten the screws from above (necessary for use with slide rail).
Updated Version 4
Decreased profile of rib material to make screw installation process easier, decreased cross section of individual ribs to allow them to bend more. Problems: Too flimsy in general, and particularly at tips.
Updated Version 5
Restored rib material and eliminated one triangular cut to solve tearing issue, attempted to print entirely without supports. Problems: Poor print quality due to lack of supports.
Updated Version 6
Used solid tip and fewer ribs in the other section. Assembly with screws remained awkward.
Updated Version 7
Switched cuts to the inside wall and eliminated redundant rib.
