Difference between revisions of "Gripper History"

From Humanoid Robots Wiki
Jump to: navigation, search
(Created page with "==Gripper Design Iterations== Original Design: thumb|The non-optimized gripper based on the UMI study Problems: Too flexible at fingertips, too stiff in...")
 
(Gripper Design Iterations)
Line 32: Line 32:
  
 
Used solid tip and fewer ribs in the other section.
 
Used solid tip and fewer ribs in the other section.
 +
 +
Problems: Tip will not bend around objects
 
Assembly with screws remained awkward
 
Assembly with screws remained awkward
 
Updated version 7:
 
Updated version 7:

Revision as of 04:42, 1 June 2024

Gripper Design Iterations

Original Design:

The non-optimized gripper based on the UMI study

Problems: Too flexible at fingertips, too stiff in inner surface Updated version 1:

Updated version 1

Made ribs thinner at their ends so that they would bend more easily Added triangular cuts along the inner surface to allow the material to flex Problems: The triangular cut closest to the tip caused the inner surface of the grippers to tear

Updated version 2:

Updated Version 2

Moved slots to only align with the three thickest ribs, reducing potential for tears Created an angled profile where the tips of the grippers are narrower than the base Problems: Screw holes were too large for screws to be inserted from below, tears persisted in some cases

Updated version 3:

Updated version 3

Decreased hole size to allow for better threading Problems: tears persisted, insufficient clearance for hex key to actually tighten the screws from above (necessary for use with slide rail)

Updated version 4:

Updated version 4

Decreased profile of rib material to make screw installation process easier, decreased cross section of individual ribs to allow them to bend more Problems: too flimsy in general, and particularly at tips

Updated version 5:

Updated version 5

Restored rib material and eliminated one triangular cut to solve tearing issue, attempted to print entirely without supports Problems: poor print quality due to lack of supports Updated version 6:

Used solid tip and fewer ribs in the other section.

Problems: Tip will not bend around objects Assembly with screws remained awkward Updated version 7:


Decreased profile of rib material to make screw installation process easier