Difference between revisions of "Stompy To-Do List"

From Humanoid Robots Wiki
Jump to: navigation, search
 
(2 intermediate revisions by the same user not shown)
Line 12: Line 12:
 
* Debug issues with the [[CAN Bus]] - specifically, write our own driver for the MCP2515 IC (one of the most common ICs for sending and receiving messages over a CAN bus)
 
* Debug issues with the [[CAN Bus]] - specifically, write our own driver for the MCP2515 IC (one of the most common ICs for sending and receiving messages over a CAN bus)
 
* Set up continuous integration for building and flashing the full operating system
 
* Set up continuous integration for building and flashing the full operating system
 +
 +
=== Actuator ===
 +
 +
* Build on top of a good open-source actuator like the [[SPIN Servo]], [[MIT Cheetah]] or [[OBot]] actuator to design and fabricate our own open-source actuator
  
 
=== Electronics ===
 
=== Electronics ===

Latest revision as of 19:33, 29 April 2024

This document acts as a progress tracker for the Stompy robot build.

To Do[edit]

Teleop[edit]

  • Create a VR interface for controlling Stompy in simulation
  • Port VR interface to work on the full robot

Firmware[edit]

  • Debug issues with the CAN Bus - specifically, write our own driver for the MCP2515 IC (one of the most common ICs for sending and receiving messages over a CAN bus)
  • Set up continuous integration for building and flashing the full operating system

Actuator[edit]

  • Build on top of a good open-source actuator like the SPIN Servo, MIT Cheetah or OBot actuator to design and fabricate our own open-source actuator

Electronics[edit]

  • Understand how to build a PCB and update the Building a PCB guide
    • Get PCBs designed and shipped
    • Two PCBs: One for the head and one for the body
      • Head PCB will mount a Jetson Nano. It will have two MIPI CSI ports for two cameras from the eyes, plus audio and speakers. The Jetson Nano will act as a "tokenizer" which multiplexes the signals over ethernet to the main board in the body
      • The body PCB will mount a full Jetson Orin, as well as the IMU, CAN tranceivers, and power management