Difference between revisions of "Stompy To-Do List"
(Created page with "This document acts as a progress tracker for the Stompy robot build. == To Do == === Teleop === * Create a VR interface === Firmware === * Get * === Electronics ===...") |
|||
| (3 intermediate revisions by the same user not shown) | |||
| Line 5: | Line 5: | ||
=== Teleop === | === Teleop === | ||
| − | * Create a VR interface | + | * Create a VR interface for controlling Stompy in simulation |
| + | * Port VR interface to work on the full robot | ||
=== Firmware === | === Firmware === | ||
| − | * | + | * Debug issues with the [[CAN Bus]] - specifically, write our own driver for the MCP2515 IC (one of the most common ICs for sending and receiving messages over a CAN bus) |
| − | * | + | * Set up continuous integration for building and flashing the full operating system |
| + | |||
| + | === Actuator === | ||
| + | |||
| + | * Build on top of a good open-source actuator like the [[SPIN Servo]], [[MIT Cheetah]] or [[OBot]] actuator to design and fabricate our own open-source actuator | ||
=== Electronics === | === Electronics === | ||
| Line 19: | Line 24: | ||
*** Head PCB will mount a Jetson Nano. It will have two MIPI CSI ports for two cameras from the eyes, plus audio and speakers. The Jetson Nano will act as a "tokenizer" which multiplexes the signals over ethernet to the main board in the body | *** Head PCB will mount a Jetson Nano. It will have two MIPI CSI ports for two cameras from the eyes, plus audio and speakers. The Jetson Nano will act as a "tokenizer" which multiplexes the signals over ethernet to the main board in the body | ||
*** The body PCB will mount a full Jetson Orin, as well as the IMU, CAN tranceivers, and power management | *** The body PCB will mount a full Jetson Orin, as well as the IMU, CAN tranceivers, and power management | ||
| − | |||
Latest revision as of 19:33, 29 April 2024
This document acts as a progress tracker for the Stompy robot build.
To Do[edit]
Teleop[edit]
- Create a VR interface for controlling Stompy in simulation
- Port VR interface to work on the full robot
Firmware[edit]
- Debug issues with the CAN Bus - specifically, write our own driver for the MCP2515 IC (one of the most common ICs for sending and receiving messages over a CAN bus)
- Set up continuous integration for building and flashing the full operating system
Actuator[edit]
- Build on top of a good open-source actuator like the SPIN Servo, MIT Cheetah or OBot actuator to design and fabricate our own open-source actuator
Electronics[edit]
- Understand how to build a PCB and update the Building a PCB guide
- Get PCBs designed and shipped
- Two PCBs: One for the head and one for the body
- Head PCB will mount a Jetson Nano. It will have two MIPI CSI ports for two cameras from the eyes, plus audio and speakers. The Jetson Nano will act as a "tokenizer" which multiplexes the signals over ethernet to the main board in the body
- The body PCB will mount a full Jetson Orin, as well as the IMU, CAN tranceivers, and power management
