Difference between revisions of "Waveshare LCDs"
| Line 18: | Line 18: | ||
! Function !! Jetson Pin !! BCM Pin | ! Function !! Jetson Pin !! BCM Pin | ||
|- | |- | ||
| − | | | + | | 3v3 || 1 || 3v3 |
|- | |- | ||
| − | | | + | | GND || 6 || GND |
|- | |- | ||
| − | | | + | | DIN/MOSI || 19 || D10 (Automatically selected by Jetson-GPIO) |
|- | |- | ||
| − | | | + | | SCK || 23 || D11 (Automatically selected) |
|- | |- | ||
| − | | | + | | CS || 24 || CE0 (Automatically selected) |
|- | |- | ||
| − | | | + | | DC || 22 || D25 |
|- | |- | ||
| − | | | + | | RST || 31 || D6 |
|- | |- | ||
| − | | | + | | BL || 32 || D12 |
|} | |} | ||
Revision as of 02:07, 1 September 2024
Instructions to run the Waveshare 1.69in LCDs on the Jetson carrier boards
Note the Linux BCM mappings in the image shown. Theoretically with the Jetson.GPIO library, you are able to use either the physical board pin mapping or the BCM mapping, but this process has only been vetted for the BCM mode. When referring to pins in the Python package, use the BCM mapping. For example, if you use pin 32, use "D12" when referring to the pin. With the Adafruit package, this is written as "board.D12"
The 1.5 Inch LCD Module page actually tells you how to set up the Jetson for the Waveshare LCDs. However, since it uses a different controller, the actual firmware needs to be modified.
You can find the draft changes repo here.
Steps to reproduce:
- On Jetson, use the jetson-io to enable SPI1. Steps are shown in the 1.5 inch LCD Module guide.
- Power down the Jetson and wire up the display using the following pinout:
| Function | Jetson Pin | BCM Pin |
|---|---|---|
| 3v3 | 1 | 3v3 |
| GND | 6 | GND |
| DIN/MOSI | 19 | D10 (Automatically selected by Jetson-GPIO) |
| SCK | 23 | D11 (Automatically selected) |
| CS | 24 | CE0 (Automatically selected) |
| DC | 22 | D25 |
| RST | 31 | D6 |
| BL | 32 | D12 |
- Clone the repository and run the code. You may need to install the following dependencies:
TBD
