49
edits
Changes
Created page with "= Developing Custom Firmware = == For the Jetson Orin Nano == = Flashing = = Notes: - Current Design constraints: - Based off of the availability of parts in JLCPCB...."
= Developing Custom Firmware =
== For the Jetson Orin Nano ==
= Flashing =
=
Notes:
- Current Design constraints:
- Based off of the availability of parts in JLCPCB. Possibility of parts not being found or existing.
-
- Flashing is done with the flash.sh script through the following command
$ sudo ./flash.sh <board> <rootdev>
where board is the actual board (Jetson-Nano-XX, etc.)
rootdev determines what type of device is being flahed. Use mmcblk0pc1 to flash a local storage device (eMMC or SD card)
- TO begin flashing, put the device into force recovery mode and then press reset.
- Run the flash script using the previous command specified.
Flash using a convenient script:
- To avoid having to specify the rootdev andthe board configurations, can use the custom flashing script:
-
Using GPIO Pins to program protocol:
- you can use the rasberry pi libraries to interface with the pins, configuring them to whatever layout that is needed.
- Example: it is possible to direclty interface with the i2c system in the nano by using the
== For the Jetson Orin Nano ==
= Flashing =
=
Notes:
- Current Design constraints:
- Based off of the availability of parts in JLCPCB. Possibility of parts not being found or existing.
-
- Flashing is done with the flash.sh script through the following command
$ sudo ./flash.sh <board> <rootdev>
where board is the actual board (Jetson-Nano-XX, etc.)
rootdev determines what type of device is being flahed. Use mmcblk0pc1 to flash a local storage device (eMMC or SD card)
- TO begin flashing, put the device into force recovery mode and then press reset.
- Run the flash script using the previous command specified.
Flash using a convenient script:
- To avoid having to specify the rootdev andthe board configurations, can use the custom flashing script:
-
Using GPIO Pins to program protocol:
- you can use the rasberry pi libraries to interface with the pins, configuring them to whatever layout that is needed.
- Example: it is possible to direclty interface with the i2c system in the nano by using the